8) Insert the rubberized
connections into the electronic
head openings and press it in
place.
9) Fully tighten the fasteners on both
valve connections securing the bypass
valves.
7) Install the blue bypass valves
onto the connections on the
electronic head.
10) Attach and tighten a MNPT
Fitting onto the connections on
each of the bypass valves.
11) Apply plumbers' tape to
both MNPT Fittings.
Questions? Call (800)-589-5592 5
Installing the Softener Electronic Head
Salt-Based Water Softener
To Next Page
Loading...
