Spring Well SS+ - Testing the System

Testing the System
51) While the water is still off,
open a cold bathtub faucet all
the way.
52) Before turning the water back onto
the home ensure the shut off valve is
in the off position.
50) Before turning the water
back on to the home, use the
provided spanner wrench to
fully tighten the pre-filter
housing.
53) Also ensure the softener
tank is set to bypass.
54) Turn on the water to the
home and inspect the shut off
valve for leaks.
55) If no leaks are detected, open
the shut off valve and allow water
to flow through the tank bypass.
Inspect for leaks.
Questions? Call (800)-589-5592 12
Off
56) If no leaks are detected,
open the tank bypass and allow
water to flow through the
softening tank.
57) Allow water to run through
the system for 5-10 minutes. It is
normal to see a small amount of
sediment during this time.
Bypass
Salt-Based Water Softener