IMPORTANT! The carbon media inside the filter system MUST soak in water for a minimum of
48 hours prior to installation
Carbon Soak Instructions (48 Hours Prior)
Carbon Filter
Tank (CF+)
Hose Bib
Assembly (x2)
Lawn Hoses (x2) and
access to a faucet
This step will require the materials listed below
2) Due to weight, stage the tank
near the installation area. The
two connectors will allow you to
route 1 hose to the tank and 1
hose away from the tank.
3) Connect the hose from the
faucet into the Inlet on the tank.
Connect the open hose to the
outlet and lead away from your
work area.
4) Run the faucet until you see
water exiting the other hose.
5) Disconnect the Hose Bib
adapters from the Carbon Filter
Tank
6) Set the tank aside and
allow it to sit for 48 hours.
1) Thread a Hose Bib into the
inlet and outlet of the Carbon
Filter Tank (CF+)
Questions? Call (800)-589-5592 4
CF+ System
To Next Page
Loading...
Need help?
General
