IMPORTANT! The carbon media must be flushed on both tanks prior to install
Carbon Flush Instructions
This step will require the materials listed below
7) This step can only be
performed after the tank has
been soaked for 48 hours.
8) Attach the Hose Bib
Assembly onto the inlet and
outlet ports.
9) Attach the hoses to the tank.
The hose leading to the inlet will
be connected to a faucet. The
outlet hose will allow the water
to drain.
10) Run the hose and allow the
water to flush out the tank until
the water runs clear.
11) Switch the hoses to now
run the water through the
outlet. Allow the water to
flow in the opposite
direction until it runs clear.
12) Remove the hose bib
assemblies from the Carbon
Filter tank.
Carbon Filter
Tank (CF+)
Hose Bib
Assembly (x2)
Lawn Hoses (x2) and
access to a faucet
Questions? Call (800)-589-5592 5
CF+ System
To Next Page
Loading...
Need help?
General
