SPT SD-2201W - Wash Cycle Programs; Starting a Wash Cycle

Wach Cycle Table
HO TE:
= Rinse-Aid required
Heavy
Normal
Light
Glass
Speed
For the heaviest soiled loads,
such as pots,pans,casserole
dishes and dishes that have
been sitting with dried food
on them for a while_
Soak
Pre-wash
Pre-wash(122°F)
Wash (131°F)
Wash (122°F)
Rinse
Rinse (149°F)
Drying
18g 100 0A24 14_5
For normally soiled loads,
such as pots, plates,glasses
and lightly soiled pans_
standard daily cycle_
Pre-wash
Pre-wash
Wash (131°F)
Rinse
Rinse (149°F)
Drying
18g 85 0361 12
For lightly soiled loads,such
as plates,glasses,bowls and
lightly soiled pans_
Pre=wash
Pre-wash (122°F)
Wash (122°F)
Rinse
Rinse (140°F)
Drying
18g 75 0,311 12
For lightly soiled loads, such
as glasses, crystal and
fine china_
Ashorter wash for lightly
soiled loads that do not
need drying_
Pre-wash
Wash(122°F)
Rinse 15g_ 70 0274 9_7
Rinse (140°F)
Drying
Pre-wash
Pre-wash(122°F)
Wash (122°F) 15g_ 45 0233 12
Rinse
Rinse(131°F)
06
To rinse dishes that you Pre-wash / 10 0_01 2_5
plan to wash laten
Starting A Wash Cycle
Once the dishwasher is loaded, follow these instructions to start the wash cycle:
1. Ensure the dishwasher is properly connected to power supply.
2. Ensure the water supply is properly connected and is turned on to full pressure.
4. Add detergent and check Rinse Aid is full.
5. Close the door and press the POWER button to turn on the dishwasher.
6. Rotate the knob to desired program: Heavy-> Normal -> Light-> Glass-> Speed ->
Soak.
7. Press the START/PAUSE button to begin the wash cycle.
NOTE: When the START/PAUSE button is pressed during a wash cycle, unit's operation
is suspended and cycle indicator light will stop blinking. During the pause, the unit will beep
every minute until the START/PAUSE button is pressed again and unit resumes operation.
11