ttenfion:
The installation of the pipes
and electrical equipments
should be done by professionals,
Electrical Shock Hazard
Disconnect electrical power before
installing dishwasher.
Failure to do so can result in death
or electrical shock.
Unpacking
Have at least two people to move and install the dishwasher to prevent personal injuries.
Remove all packaging materials: shipping tape, foam pieces, etc. before use. Do not use
sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. Check and
make sure all parts necessary for installation are included. If parts are missing, please
contact Sunpentown at 1-800-330-0388. The dishwasher must be placed on a level and
flat surface that can support the weight when the dishwasher is fully loaded.
Positioning
This dishwasher is designed for countertop installation. The dishwasher is equipped
with water supply and drain hoses that can be positioned to the right or the left
to facilitate proper installation. Make sure water supply/faucet connection is within
reach of the inlet and drain hose assembly (5 ft).
E|ectrical Requirements
Read all safety precautions listed at the beginning of the manual. Make sure the
electrical outlet is within reach of the power supply cord (4.5 ft). It is recommended
to not use receptacles that can be turned on/off by a switch or pull chain.
Refer to the rating label and be sure the voltage and frequency corresponds to the
power supply. Use a dedicated circuit that is rated for l 0 amps.
The dishwasher is equipped with a power supply cord with a 3-prong grounding plug.
The cord must be plugged into a mating 3-pronged wall receptacle. If a mating wall
receptacle is not available, it is the personal responsibility of the customer to have a
properly grounded, 3-pring wall receptacle installed by a certified electrian.
To Next Page
Loading...
