Connecting the Dishwasher
Hose
FaucetAdapter&Washer
Quick Connect
Your dishwasher is equipped with a Faucet Adapter (installed on the Quick Connect),
Quick Connect, Drain and Inlet Hose. The faucet adapter must be installed on the
faucet before connecting the dishwasher.
Remove the Faucet Adatper by pulling back the locking collar
on the Quick Connect; while pulling the Faucet Adapter in the
opposite direction.
Locking Collar
The Faucet Adapter is compatible with either female
(inside) or male (outside) threaded faucet connections:
• If your faucet is "female" type, both rubber washers
must be installed inside the faucet adapter.
• If your faucet is "male" type, use only one rubber
washer. Remove the second rubber washer.
Installing Quick Connect to faucet
Inlet Hose
Drain Hose
Faucet Adapter
Locking Collar
Pressure Relief Valve
Quick Connect assembly
To Next Page
Loading...
