SPT SD-9241SS - Wash Cycle Operations

9
Light
Heavy
Normal
18g
18 g
18g
For normally soiled loads,
such as , plates,glasses
and lightly soiled pans.
standard daily cycle.
pots
For lightly soiled loads,such
as plates,glasses,bowls and
lightly soiled pans.
For the heaviest soiled
loads, such as pots, pans,
casserole dishes and dishes
that have been sitting with
dried food on them for a
while.
A shorter wash for lightly
soiled loads .
Speed
Pre-wash
Pre-wash (122 )
Wash (136 )
Rinse
Rinse (149 )
Drying
°
°
°
F
F
F
Pre-wash
Wash (136 )
Rinse
Rinse (149 )
Drying
°
°
F
F
Wash (122 )
Rinse
Drying
Pre-wash
F
Rinse
(140 F)
°
°
Pre-Wash
Wash
Rinse (131 )
Drying
(122 F)
F
°
°
18g.
115
100
130
65
4.6
3.65
3.67
2.75
For di shes that just need a
quick rinse.
25
1.9
3.7
135
All in 1
Rinse
For all soiled loads, such as
pots,pans,c asserole dishes
and dishes that have been
sitting with dried foo d on them
for a while.
Pre-wash
Pre-wash
wash 136 F
Rinse 154 F
Drying.
（ ）
（ ）
°
°
All in1
(AHAM)
Pre-Wash
Pre-Wash
0.6
0.58
0.545
0.43
0.05
0.32
Starting a wash cycle:
Once the dishwasher is loaded, follow these instructions to start the wash cycle:
1. Ensure the dishwasher is properly connected to power supply.
2. Ensure the water supply is properly connected and is turned on to full pressure.
4. Add detergent and check Rinse Aid is full.
5. Close the door and press the ON/OFF button to turn on the dishwasher.
6. Press the PROG button to select desired program: All-in-1 -> Heavy -> Normal -> Light ->
Rinse -> Speed.
7. If you wish delay the start time, press the DELAY button to set (1 to 24 hours)
8. Press the START/PAUSE button to begin the wash cycle.
Changing the Wash Program
You can change the wash program if the unit just started and only ran for a short time.
Otherwise, detergent may have been released and water drained. If this is the case, the
detergent dispenser must be relled.
Open the door slightly, press and hold the PROG button for 3 seconds. Press PROG button
again to select desired mode. Close the door.