SPT SD-9241SS - Connecting the Dishwasher; Disconnecting the Dishwasher

Locking Collar
The Faucet Adapter is compatible with either female
(inside) or male (outside) threaded faucet connections:
· If your faucet is “female” type, both rubber washers
must be installed inside the faucet adapter.
· If your faucet is “male” type, use only one rubber
washer. Remove the second rubber washer.
Connecting the Dishwasher
Installing Quick Connect to faucet
Remove the Faucet Adapter by pulling back the locking collar
on the Quick Connect; while pulling the Faucet Adapter in the
opposite direction.
IMPORTANT
- Once you turn on the water supply (even if turned off immediately), the inlet hose will be pressurized.
- To relieve the water pressure (make sure water supply is turned off), press and hold the red
pressure relief button on the Quick Connect until the ow of water stops.
WARNING
Failure to relieve water pressure before disconnecting the Quick Connect may result in back-pressure
over-spray. The temperature of incoming water may be very hot, and back-pressure over-spray can
cause severe burns and/or scalding.
1. Screw the Faucet Adapter onto (or into) the
faucet. Check for leaks (use Teon or plumbers
tape to eliminate any leaks if necessary).
2. Attach the Quick Connect assembly onto the
Faucet Adapter - pull down on the locking collar,
while pushing the Quick Connect upwards onto
the Faucet Adapter.
3. Release the locking collar when the Quick
Connect Assembly snap onto the Faucet
Adapter. Verify connection is secure.
4. Slowing turn on water and check for any signs
of water leak. If leak is located, immediately
turn off the water supply and repair leak.
Disconnecting the Dishwasher
1. Turn off water supply at the faucet.
2. Disconnect the power supply cord.
3. Release water pressure: press and hold the red Pressure Relief Valve until ow of water stops.
4. Disconnect the Quick Connect by pulling down on the locking collar and release from Faucet Adapter.
5