SAFETY PRACTICES
GENERAL SAFETY PRACTICES
• The primary responsibility for safe operation of the Spudnik Conveyor lies with the
owner/operator.
• OSHA (Occupational Safety and Health Administration) requires that all operators be
trained at the time of initial assignment, and annually thereafter by the employer, in
the safe operation of the Conveyor.
• Read and understand the operator manual before operating, maintaining, or
adjusting Conveyor.
• Untrained individuals and children should not be allowed on or around Conveyor at
anytime.
• Keep hands, feet, long hair, and clothing away from moving and/or rotating parts.
• Never wear ill-fitting baggy, or frayed clothing when working around or on any drive
system component.
• Do not attempt to service, lubricate, clean or adjust Conveyor while it is running.
• Inspect all mechanisms before starting Conveyor and replace all worn or damaged
parts.
• Make sure all guards and shields are properly installed and secured before
operating Conveyor.
• Replace all worn or missing bolts with SAE Grade 5 or better unless specifically
stated otherwise.
4/25/2002
7
To Next Page
Loading...