14
The APV in-line filter is inserted in the fluid inlet port
of the heat exchanger through an opening in the
follower and closed with a full-faced gasket blind
cover.
The in-line filter mesh size is 2.5 mm (0.1 inch).
Where an in-line filter is purchased for an existing
APV PHE, please check whether the follower is
prepared for the installation of an in-line filter. A
replacement follower or machining may become
necessary.
3. General safety precautions
Always observe the Safety Notes designated by
the Warning symbol:Ì! Listed throughout this
manual.
APV Plate Heat Exchangers are designed and
manufactured with due consideration and care for
generally accepted safety standards. As with any
mechanical device, the proper and safe performance
of the equipment depends on safe handling,
operation, and maintenance.
Ì! The following general safety precautions must
be followed in order to avoid personal injury or
equipment damage:
1. Always observe any applicable local and
national safety codes.
2. Always use appropriate protective gear, such
as safety gloves and safety shoes when
touching and handling the equipment.
3. Follow proper lifting procedures while
handling the equipment.
4. Never expose the equipment to heat,
aggressive chemicals or mechanical impact
that can damage the equipment.
5. Only qualified persons should handle and
operate the equipment.
To Next Page
Loading...
