To Next PageTo Next PageWhat to do if my SPX Hankison HPRP100 refrigeration system is not functioning properly?
If the power light is off, ensure the unit is receiving power. Also, close the disconnect switch and check for continuity. An electrician should inspect the electrical connections. Verify the unit operates within the minimum and maximum temperature ranges. Clean the condenser and ensure there's adequate airflow.
Why is there high pressure drop across my SPX Hankison HPRP100 Dehumidifier?
A high-pressure drop could be due to the flow rate. Check the flow rate and replace the filter element.
What to do if there is water downstream of my SPX Hankison HPRP100 Dehumidifier?
To address water downstream, blow out the system with dry air. Also, check the valve positions and ensure correct connections. Insulate or heat trace air lines exposed to low ambients, or use dry air to lower the dew point. Consider installing a separator ahead of the dryer.
General| Model | HPRP100 |
|---|---|
| Category | Dehumidifier |
| Manufacturer | SPX Hankison |
| Type | Refrigerated Air Dryer |
| Capacity | 100 SCFM |
| Inlet Temperature | 100°F |
| Power Supply | 115V/1Ph/60Hz |
| Weight | 145 lbs |
| Airflow Capacity | 100 SCFM |
| Operating Pressure | 150 psi |
| Dimensions | 20" x 20" x 29" |
Safety precautions for devices containing pressure.
Guidelines for safe electrical installation and service.
Lists common fault types and their indicators.
Symptoms and causes of water appearing downstream of the dryer.
Troubleshooting high pressure drop across the dryer.
Diagnosing issues when the dew point indicator is in the red area.
Addressing problems with the refrigeration compressor cycling or not powering on.
Symptoms and causes of water appearing downstream of the dryer.
Identifies and explains common dryer faults and their indicators.
