To Next PageTo Next PageWhat to do if my SPX Hankison HPRP600 Dehumidifier refrigeration system is not functioning properly?
If the power light is off, ensure the unit is receiving power. Also, close the disconnect switch and check for continuity. An electrician should inspect the electrical connections. Verify the unit operates within the minimum and maximum temperature ranges. Clean the condenser and ensure there's adequate airflow.
What to do if there is water downstream of my SPX Hankison HPRP600 Dehumidifier?
To address water downstream, blow out the system with dry air. Also, check the valve positions and ensure correct connections. Insulate or heat trace air lines exposed to low ambients, or use dry air to lower the dew point. Consider installing a separator ahead of the dryer.
Why is there high pressure drop across my SPX Hankison HPRP600?
A high-pressure drop could be due to the flow rate. Check the flow rate and replace the filter element.
General| Model | HPRP600 |
|---|---|
| Category | Dehumidifier |
| Manufacturer | SPX Hankison |
| Type | Refrigerated |
| Airflow | 600 SCFM |
| Inlet Temperature | 100°F (37.8°C) |
| Power Supply | 230/1/60 |
| Inlet Connection | 2 in NPT |
| Outlet Connection | 2 in NPT |
Safety precautions for pressure-containing equipment.
Guidelines for safe electrical installation and service.
Specifies optimal placement, clearances, and ambient operating conditions for the dryer.
Details on connecting air inlet, air outlet, bypass, and water lines.
Guidance on connecting power supply, voltage, and phasing requirements.
Describes how the drain operates and the process of condensate discharge.
Step-by-step guide for initiating dryer operation for different models.
Instructions for setting language, date, and time via the control panel.
Lists and describes common fault conditions like low pressure, high pressure, and temperature issues.
How to calculate the dryer's maximum inlet flow capacity based on operating conditions.
Covers troubleshooting for power loss and compressor cycling issues.
Troubleshooting steps for moisture in downstream air lines for larger models.
Detailed guide for diagnosing specific faults like low pressure, high temperature, and sensor errors.
Comprehensive list of parts with part numbers for different models and electrical configurations.
Details manufacturer's warranty coverage, limitations, and duration for parts and labor.
