SPX LeakMaster - Introduction; Technical Specifications

4
Congratulations!
You are in possession of the most useful, yet simple to operate, Evaporative
Emissions (EVAP) system diagnostic tester available today. The LeakMaster’s
versatile12-voltdesignwasspecicallydevelopedtodiagnosevehicleEVAP
systems for leaks.
Inaddition,theLeakMasterwillalsondintakemanifoldsystemleaks,exhaust
system leaks, and under-dash vacuum system leaks. It will also diagnose many
other closed systems where you may suspect a leak, as well as pinpointing wind
and water leaks entering the vehicle’s passenger compartment.
TheLeakMaster’suniquedesignallowstheoperatortoconrmtheintegrityof
asystembyutilizingameteredairsystem.Ifthetoolhasconrmedaleakinthe
system being tested, it then introduces a non-toxic, diagnostic, marked vapor
(smoke) into the system. To locate the source of the leak, you simply look for the
smoke exiting the leak, or use a conventional ultraviolet (UV) lamp to view the
UV deposit left behind, which pinpoints the exact location of the leak.
TheLeakMasterisshippedlledwithafullchargeofsmoke-producingsolution
that will last approximately 500 tests.
Introduction
Height 23 in. (58.4 cm) Supply Pressure 13.0 in. H
2
O
Width 18 in. (45.7) Supply Volume 15 liters per minute
Depth 9 in. (24.1 cm) Operating Temperature Range 45°F to 140°F (7.2°C to 60°C)
Weight 17 lbs. (7.6 kg) Supply Line 12 feet (3.6 m)
Ship Weight 20 lb. (9.0 kg) Power Supply Line 12 feet (3.6 m)
Power Supply 12V DC Remote Starter Cable 12 feet (3.6 m)
Amperage Usage 15 amps
Technical Specications