SPXFLOW Delair EtsilineCommPact - General Safety Guidelines; Electrical Safety Precautions; Operational Safety Precautions

ACMM16WC0002 REV0.2 INSTRUCTION MANUAL DELAIR® ETSILINE COMMPACT
8
ACMM16WC0002 INSTRUCTION MANUAL DELAIR® ETSILINE COMMPACT
CHAPTER 2 PAGE 8
Do not operate this equipment until the safety information and instructions in this user guide have been
read and understood by all personnel concerned.
WARNING
• User responsibility. Failure or improper selection or improper use of the products de-
scribed herein or related items can cause death, personal injury and property damage.
General
Correct use of the air dryer is important for your personal safety and for trouble-free functioning of the air
dryer. Incorrect use can cause damage to the air dryeror can lead to incorrect air supply.
WARNING
• Read this manual before you start the installation and putting into operation of the air
generator. Prevent accidents and damage to this equipment.
• Contact your supplier if you detect a problem that you cannot solve with this manual.
• Use the air dryer in accordance with its purpose.
• Onlyservice-engineers,thatarequaliedtoworkonelectricandpneumaticequip-
ment,areallowedtodotheinstallation,maintenanceandrepairs.Unqualiedpeople
are not allowed to repair the equipment.
• Do not tamper or experiment with the equipment. Do not exceed the technical speci-
cationsoftheairdrier.
Electricity
WARNING WARNING
• Onlyservice-engineers,thatarequaliedtoworkonelectricequipment,areallowed
to do the installation, maintenance and reparations.
• Disconnect the main power supply before you do the maintenance or repair.
• If a service-engineer has to work on the air drier while the electric power is connect-
ed, the service-engineer must be very careful with respect to the electric hazards.
Safety precautions
WARNING WARNING
• Makesurethattheventilationrateissufcientintheroomwheretheairdrieris
installed.
• Keep the ambient temperature for the air drier between -10 and +45 °C.
• Install the peripheral equipment and piping/tubing according to standard procedures.
• Ensure proper and safe operation.
• Make sure that instructions concerning health and safety are compliant with the local
legislation and regulations.