SQlab 702 - Grip Angle Adjustment and Safety Precautions; Setting Grip Angle and Position; SQlab 711 Mounting Tip; Cleaning Fluid Safety

SQlab | SPORTS ERGONOMICS | 702, 710, 711 AND 7OX | EDITION US 2019-01 | Page 9
The SQlab ,  and OX grips should be mounted on a clean, grease-free handlebar.
Push the grips completely until they are fully in contact with the handlebars. Make sure to
check the correct side allocation (le / right) and set the grip angle to the neutral position.
Due to its design, the SQlab 711 grip has a much shorter hard plastic sleeve for clamp-
ing. Therefore, screwing the grip onto the handlebar is more dicult than with the other
models.
To facilitate mounting of the SQlab 711 grip, the grip can be moistened internally with
brake cleaner. When using brake cleaner make sure to keep the grip away from your body
when spraying. Brake cleaner usually sprays with extremely high pressure. Wear protec-
tive rubber gloves. It is best used outdoors.
Warning
When using cleaning fluids or brake cleaners, it is essential to observe the corresponding safety instructions for their use and to use
appropriate safety equipment (chemical protection goggles and latex gloves).
Avoid contact with skin and eyes. Ensure adequate ventilation. Avoid breathing in vapours. If the air pollution is above the permitted
limit, appropriate respiratory protection is required.
• Inhalation
Provide aected persons with access to fresh air. Keep the aected person warm and calm. Seek immediate medical attention.
• Ingestion
Rinse thoroughly with water. Move the aected person into the fresh air and place them in warm and calm position that facilitates
breathing. Do not induce vomiting. Never put anything in an unconscious person’s mouth.
• Skin contact
Remove aected person from source of contamination. Medical help should be sought if complaints persist.
• Eye contact
Remove aected person from source of contamination. Remove contact lenses and open eyelids wide. Continue rinsing for at least
15 minutes and seek medical advice.
Grip angle adjustment
The SQlab OX and  grips have a scale
on their clamping rings. The neutral posi-
tion and the initial position on rst mount-
ing should be such that the "" of the scale
is pointing directly upwards.
Make sure that the enlarged support sur-
face of the grips is aligned so that it ts
exactly to the support surface of the hand.
The tendency is to turn the SQlab OX and
 grips forward.