To Next PageTo Next Page
Need help?Do you have a question about the SRAM Guide Ultimate and is the answer not in the manual?
General| Brake Type | Hydraulic Disc |
|---|---|
| Caliper Design | 4-Piston |
| Caliper Material | Aluminum |
| Compatibility | MatchMaker X |
| Rotor Compatibility | CenterLock, 6-Bolt |
| Adjustment | Reach Adjust |
| Intended Use | Trail, Enduro |
| Pad Material | Organic |
| Weight | 360g |
Hold hose to lever to find length for gentle bend and handlebar movement.
Use hose cutter, clean fluid, bleed brakes after cutting.
Facilitates internal routing and simplifies assembly without bleeding.
Levers are identified by "Stealth-a-majig Only" print at the hose end.
Apply grease, use T10 TORX to install barb into hose.
Fit over barb, tighten nut to 5-6 N·m.
Assemble, fill, and remove air bubbles from syringes for bleeding.
Detailed procedure for bleeding the brake system, including lever and caliper.
Rotate Contact Point Adjustment dial to desired position.
Adjust Reach Adjust knob for lever blade position (75-80mm).
