Need help?Do you have a question about the SRAM G2 R and is the answer not in the manual?
General| Category | Bicycle Accessories |
|---|---|
| Caliper Design | 2-piston |
| Lever Material | Aluminum |
| Pad Material | Organic |
| Type | Hydraulic Disc |
| Adjustment | Tool-free Reach Adjust |
Provides critical safety guidelines for handling brake fluid and servicing.
Provides steps to diagnose and fix issues like excessive lever throw or a spongy brake feel.
Lists all necessary parts, safety supplies, lubricants, and common tools for caliper service.
Step-by-step instructions for safely removing brake pads and related hardware from the caliper.
Step-by-step guide to safely remove caliper pistons from the brake caliper body.
Details the process of removing O-rings and pistons from the caliper body halves.
Instructions for removing old piston seals and installing new ones, with warnings about scratching.
Guides on applying fluid to pistons and seals, then installing them into the caliper halves.
Steps for aligning and bolting the caliper halves together with specified torque.
Steps for cutting the hose and installing a new barb and compression fitting.
Steps to push out the SwingLink pivot pin and remove the SwingLink and its bushings.
Instructions for removing the snap ring and washer securing the piston assembly, with eye hazard warning.
Describes using needle nose pliers to carefully extract the piston assembly from the lever body.
Guides on submerging the new piston assembly in brake fluid or using grease as a lubricant.
Details installing the lubricated piston, washer, and securing it with the snap ring using pliers.
Outlines the sequence of accelerating and braking to deposit pad material onto the rotor.
Alerts users to the risks of heavy braking during the bed-in process if unfamiliar with brake operation.
To Next Page
