EasyManuals Logo

SSANGYONG KORANDO 2005 User Manual

SSANGYONG KORANDO 2005
214 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #136 background imageLoading...
Page #136 background image
6–8 IN CASE OF EMERGENCY
Attempts to start the engine of the
vehicle with the discharged battery
should be made at intervals of about one
minute and should not last longer than
15 seconds each.
Once the previously discharged vehicle is
running:
6. Carefully disconnect the ground
connection(“-”). Begin with the vehicle
with the discharged battery.
Leave the discharged vehicle running.
7. Disconnect the negative lead from
vehicle providing the jump.
8. Disconnect the “+” lead from both
batteries.
9. Operate the discharged vehicle for
approximately 20 minutes. This will allow
the charging system to recharge your
battery.
10. If this discharge condition recurs, consult
your Ssangyong dealer or an authorized
Ssangyong Service Operation.
WARNING
Last connection to the vehicle to
be charged should NOT be made
to the negative ("–") battery
terminal.
Attach the clamp for this last
connection to a steel bracket
bolted to the engine block.
This last connection should be as
far away from the battery as
possible.
Connecting the jumper cable to the
negative terminal of the dis-
charged battery could result in
arcing and possibly a battery ex-
plosion. Serious personal injury or
vehicle damage can result.
4. Make the last connection to a suitable
ground, such as a steel bracket bolted
to the engine block.
5. The engine of the vehicle providing the
jump start can be allowed to run during
the jump start.
Attaching Jumper Cables
To jump start your battery, connect the
jumper cables in the following order:
1. Connect one clamp of the first lead of
the jumper cable to the positive terminal
of the charged battery. (identified by a
"+" sign on the battery case or terminal.)
2. Connect other end of this same jumper
cable lead to the positive terminal of the
discharged battery. (the "+" terminal.)
3. Connect one end of the second lead on
jumper cable to the negative terminal of
the charged battery. (identified by a "–"
sign on the battery case or terminal.)
K140_RHD_EN_06.p65 2004-11-11, ¿ÀÈÄ 4:098

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SSANGYONG KORANDO 2005 and is the answer not in the manual?

SSANGYONG KORANDO 2005 Specifications

General IconGeneral
BrandSSANGYONG
ModelKORANDO 2005
CategoryAutomobile
LanguageEnglish

Related product manuals