INSTRUMENTS AND CONTROLS 3–19
LIGHT SWITCH
To turn the light on or off, rotate the knob
on the end of the combination switch lever.
There are three position;
“OFF” Position
All lights are off.
Position
Position, tail, license plate and instrument
panel lights are illuminated.
Position
Headlight (low beam) and all the above lights
are illuminated.
LIGHT SWITCH WARNING CHIME
The chime sounds to remind you to turn off
the lights if the driver’s door is opened with
them switched on when the ignition key is
removed.
NOTE
The asymmetrical low beam in-
creases the field of vision on the
right-hand side of the lane. When
driving in countries which drive on
the left, the 15° section of the
headlamp lenses must have a black
cover strip applied.
CAUTION
Battery will discharge.
Do not leave the lights on while en-
gine is off.
Battery Saver (Automatically turns off
the lights)
To prevent the battery from discharging, the
tail lamp will be go out automatically when a
driver gets off (remove key, open and close
the driver’s door) with the tail lamp ON.
When inserting the key into key switch, the
tail lamp comes again.
K140_RHD_EN_03.p65 2004-11-11, ¿ÀÈÄ 4:0819
To Next Page
Loading...
Need help?
General
