STARTING AND OPERATING 2–13
• ‘2H’
↔↔
↔↔
↔
‘4L’
Follow the ‘2H’
↔
‘4H’
↔
‘4L’ operation.
WARNING
In case of part-time 4WD, do not use
4WD for normal driving on dry pave-
ment. It will cause unnecessary noise,
wear and fuel economy.
WARNING
To shift ‘4L’ or ‘4H’ position, com-
pletely stop the vehicle and always
depress the clutch pedal, for manual
transmission, or position the selec-
tor lever to “N”, for automatic trans-
mission, and turn the 4WD switch to
‘4L’ or ‘4H’.
• ‘4H’
↔↔
↔↔
↔
‘4L’ (common)
To shift from ‘4H’ to ‘4L’, the vehicle
should be stopped.
Depressing the clutch pedal (with
manual transmission) or moving the
selector lever to ‘N’ position (with au-
tomatic transmission), rotate the 4WD
switch to ‘4L’. The 4WD low (‘4L’) indi-
cator light may come on.
When ‘4L’ operation is no longer needed,
rotate the transfer switch from ‘4L’ to
4H’. To shift from ‘4L’ to ‘4H’, stop the
vehicle and depress the clutch pedal (on
manual transmission) or move the selec-
tor lever to ‘N’ position (on automatic
transmission) and rotate the 4WD switch
to ‘4H’.
T.O.D (TORQUE ON DEMAND)*
Full time vehicle is equipped with T.O.D sys-
tem.
T.O.D privides the suitable power to front &
rear axle based on sensing data by trans-
fer case control unit, e.g. propeller shaft
speed, operating range of 4H & 4L and op-
erating of brake/ABS.
T.O.D will help your vehicle to remain
steerable, stable around the corner espe-
cially.
NOTE
When shifting ‘4L’
→→
→→
→
‘4H’ in automatic
transmission, foot brake and shift the
selector lever to “N
→→
→→
→
R
→→
→→
→
N” after
4WD LOW indicator OFF for smooth
shifting.
K140_RHD_EN_02.p65 2004-11-11, ¿ÀÈÄ 4:0813
To Next Page
Loading...
Need help?
General
