INSTRUMENTS AND CONTROLS 3–25
• Tap up while cruise control system is
running
1. Push up the ACCEL.SET. switch of a
cruise control lever less than 0.5 sec-
ond per one switching while the cruise
control system is running. This is a tap
up switching.
2. When you operate a tap-up switching,
the vehicle is accelerated for 1.3km/h
over the previous set speed.
3. If you want to accelerate for 13km/h, op-
erate the tap-up switching ten times
without accelerating with cruise control
system.
Decelerating with cruise control sys-
tem
• While Cruise control system is running
1. Push down the DECEL.SET. Switch of a
cruise control lever and hold it until the
desired speed is reached without a
brake pedal intervention. But the cruise
control system cannot maintain the
cruise function at less than 34km/h.
2. When the desired speed is reached,
release the lever.
• When Cruise control system is not run-
ning
1. Push down the DECEL.SET. Switch of a
cruise control lever and hold it.
2. And then release the acceleration pedal,
slowly.
3. When the desired speed is reached,
release the lever. But the cruise control
system cannot maintain the cruise func-
tion at less than 34km/h.
• Tap down while cruise control system
is running
1. Push down the DECEL.SET. Switch of a
cruise control lever less than 0.5 sec-
ond per one switching while the cruise
control system is running. This is a tap
down switching.
2. When you operate a tap-down switching,
the vehicle is decelerated for 1km/h be-
low the previous set speed.
3. If you want to decelerate for 10km/h, op-
erate the tap-down switching ten times
without brake pedal intervention.
K140_RHD_EN_03.p65 2004-11-11, ¿ÀÈÄ 4:0825
To Next Page
Loading...
Need help?
General
