INSTRUMENTS AND CONTROLS 3–27
CAUTION
• The speed that has been set may
not be maintained on uphill or
downhill slopes.
• The speed may drop to less than
the set speed on a steep uphill
grade. The accelerator must be
used if you want to maintain that
speed.
• The speed may increase to more
than the set speed on a steep down-
hill grade. When the speed in-
creases too much, turn off the
cruise control.
HAZARD WARNING FLASHER
SWITCH *
To turn on the hazard warning flashers,
push the hazard warning flasher switch. All
turn signal lamps will flash simultaneously
with the hazard warning indicators.
Push this switch again to turn them off.
The switch can be operated with the igni-
tion on or off.
Use the hazard warning flasher to warn
other drivers when you stop or park under
emergency conditions, or when your vehicle
becomes a traffic hazard. Avoid stopping on
the road if possible.
Using Cruise Control on Hills
How well cruise control works on hills de-
pends on the speed, load, and the steep-
ness of the hill.
When going up steep hills, you may have to
press the accelerator pedal to maintain your
speed. When going downhill, you may have
to brake or shift to a lower gear to keep your
speed down.
Applying the brake takes you out of cruise
control.
K140_RHD_EN_03.p65 2004-11-11, ¿ÀÈÄ 4:0827
To Next Page
Loading...
Need help?
General
