Ssl DD664B - User Manual

Questions and Answers

J
Joshua ChapmanAug 16, 2025
Why Ssl DD664B Car Receiver has no power?
- J
  Justin CooperAug 16, 2025
  Your Ssl Car Receiver might not be getting power because the car ignition isn't on. Ensure the ignition key is switched to “ACC” if the power supply is properly connected to the car accessory switch. Another cause could be a blown fuse, in which case you should replace it.
S
Samantha RogersAug 19, 2025
What to do if my Ssl Car Receiver produces no sound?
- J
  jonesstevenSep 12, 2025
  If your Ssl Car Receiver isn't producing any sound, first check if the volume is set to the minimum. If so, adjust it to a desired level. Also, verify that the wiring is properly connected.
W
whitepennyAug 22, 2025
How to fix Ssl Car Receiver when nothing happens when buttons are pressed?
- J
  James HillAug 22, 2025
  If nothing happens when you press the buttons on your Ssl Car Receiver, it might need to be reset. Use a pen or toothpick to press and release the Reset button. Also, the panel or main unit connectors might be dirty. Wipe the dirt off with a soft cloth moistened with cleaning alcohol.
J
Jeffery NortonAug 25, 2025
How to troubleshoot Ssl DD664B sound skipping?
- A
  Alexandra FloresAug 26, 2025
  Sound skipping on your Ssl Car Receiver can occur if the installation angle is more than 30 degrees; adjust it to less than 30 degrees. Also, the disc might be extremely dirty or defective, so clean it or try a new one.
A
angelahawkinsAug 28, 2025
What to do if Ssl DD664B disc cannot be read?
- H
  Holly BrownAug 28, 2025
  If your Ssl Car Receiver can't read the disc, make sure you're inserting it with the label facing upward. Also, the disc might be extremely dirty or defective, so try cleaning it or using a new one. If the temperature inside the car is too high, cool it off until the ambient temperature returns to normal.
W
waynecarrAug 31, 2025
Why Ssl Car Receiver power does not turn on?
- B
  Brandy SmithAug 31, 2025
  If your Ssl Car Receiver doesn't turn on and no sound is produced, a possible cause is a blown fuse. Replace it with a fuse of the same amperage. If it blows again, consult your store of purchase. Another cause could be incorrect wiring, in which case you should consult your local retailer.
J
Joseph FlemingSep 3, 2025
Why Ssl DD664B radio does not work?
- J
  James JosephSep 3, 2025
  If the radio on your Ssl Car Receiver isn't working, or the automatic station selection isn't functioning, the antenna cable might not be connected or the signals are too weak. Insert the antenna cable firmly and select a station manually.
S
Shawn LopezSep 6, 2025
How to fix bad sound of Ssl DD664B after power on?
- N
  Nicholas SchwartzSep 6, 2025
  If you notice bad sound quality from your Ssl Car Receiver right after turning it on, it could be due to water droplets forming on the internal lens when the car is parked in a humid place. Let it dry for about 1 hour with the power on.
G
George ThomasSep 9, 2025
What causes no sound output when operating Ssl DD664B with amplifiers?
- M
  Melissa HodgesSep 9, 2025
  If there is no sound output when operating your Ssl Car Receiver with amplifiers or a power antenna attached, the power antenna lead may be shorted to ground, excessive current is required, or remote on the amplifiers or power antenna. To resolve this: 1. Turn off the unit. 2. Remove all wires attached to the power antenna lead and check each wire for a possible short to ground using an ohm meter. 3. Turn on the unit. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external replay to provide remote-on voltage (excessive current required).
J
Jason CollinsSep 12, 2025
How to fix operation keys do not work on Ssl DD664B?
- J
  Jeffrey MahoneySep 12, 2025
  If the operation keys on your Ssl Car Receiver aren't working, the built-in microcomputer might not be operating properly due to noise. Press the power button for about 10 seconds to reset the unit.