DIRT BIKE OWNERS MANUAL SSR189
1. Pre-ride inspection
It is necessary for your safety, check:
• Engine oil level
• fuel, according to the route to go
• Tire pressures as indicated calibrate
• Operation of the throttle
• Operation of lights and indicators
• Alignment of management
• Proper operation of the brakes
2. Starting the Engine
Follow these steps:
1. Place the unit in contact
2. Make sure gear is in neutral
3. Check the fuel level
4. Be sure to tighten the clutch to reduce friction starter motor and
for safety.
5. Kick start lever start accelerating throttle to 1/4 "of the position
of the fist.
• Do not start the engine indoors or shortly ventilated, it
may cause accidents due the toxic exhaust fumes.
• If the engine is ignited by kick start, the dirt bike must
be stopped with the front brake.
• If you cannot start the engine in 5 seconds start the
engine via the kick again.
• Avoid sudden acceleration when the engine is cold,
as can cause serious damage.。
• Do not keep the dirt bike unnecessarily idle to avoid
overloading the motor.
3. Seated engine
We recommend that during the first 2 hours
• Do not speed excessively, suggest
circulate at a maximum speed of 50 km /
h.
• Be careful not to exceed 5000rpm for
correct transposition of metals
• Do not load the vehicle in excess
• Perform the first maintenance within 4 hour
or 30 liters of fuel consumed, and then follow
the instructions on the maintenance table.
• Use front and rear brakes independently reduces
braking efficiency, otherwise wheel can lock up
losing control.
To Next Page
Loading...
