• To maintain the dirt bike in normal course storage:
1. Replace engine oil 2. Drain the remaining gasoline from the fuel tank
and carburetor.
Then spray with anti-rust oil the inner fuel tank and close the tank lid.
3. If storage exceeding one month, the carburetor gasoline must be
drained.
• As the gasoline is flammable, the engine must be switched off during
filling and emptying of the fuel.
• Do not be lit cigarettes, sparks fire where fuel is empty or where fuel is
stored or where the dirt bike is filled with gas.
4. Remove the spark plug
5. Fill a bucket (15-20ml) of oil into clean cylinder and insert a piece of
cloth into the hole plug. Screw the spark plug is set and turn the engine
over several times by operating the starter, without turning it on.
Adjust the spark plug.
6. Remove the battery from the dirt bike. Place the battery in a
safe place where it will not freeze or expose to UV sun. Charge the battery
once a month with the regime (amperage) specified. (No more than 6 Ah)
7. Clean and dry the dirt bike. Spray painted surfaces with color fixative
and chrome surfaces with oil anti-rust.
8. Adjust the air pressure of the tires.
9. After the dirt bike is parked, lift wheels with a stand, so that the wheels
not touch the floor.
10. Cover the dirt bike with dirt bike cover.
The water pressure can damage many parts
of the dirt bike, therefore not flush the following
pressure parts: wheel hub, stop switch, fuel tank
and the portion of seat, carburetor, ignition
switch, etc.
1. After the dirt bike has been cleaned, rinsed
with fresh water. We recommend shampoo used
as any other detergent is detrimental to the paint
contain degreasing agents ammonia or caustic.
2. Dry the dirt bike.
3. Run the engine idling for a few minutes.
4. Check the brakes several times before riding
dirt bike, and make repairs or adjustments if
necessary.
To Next Page
Loading...
