SSR 189 - Engine Maintenance: Oil and Spark Plugs; Engine Oil Management

DIRT BIKE OWNERS MANUAL SSR189
1. Motor oil
- Check engine oil:
• It is advisable to do so before riding the dirt bike.
• Keep the dirt bike on firm and flat ground, on the support main stand
• Remove the dipstick and then cleaning, reinsert again without
screwing it to check the level.
• The engine oil level should be between the high and low.
- Change engine oil:
Engine oil plays an important role in the work of motor.
- Change engine oil:
Engine oil plays an important role in the work of
motor.
• Check the engine oil regularly and change oil as
indicated in the periodic table maintenance.
Steps to follow:
1. Make sure the engine is stopped. Remove the cap drainage
underneath (at the base) of the engine when engine is hot. In
this way, oil drain. Operate repeatedly kickstarter to drain
completely.
2. Clean the oil filter and assemble after cleaning.
3. Add clean oil 1100cm3. Start the engine and run at idle
speed for 2 to 3 minutes
4. After the engine stops for 1 or 2 minutes, check the oil level
to see if the engine oil is between high and low marks.
• Do not use engine oil with different degree, to prevent that the
motor fails.
• Use 10w40 semi synthetic engine oil.
• Never use recycled oil.
Select motor oil 10w40 semi synthetic engine oil.
• If this oil is not available, read the specifications techniques and find a
substitute available to the local ambient temperature.
- Clean the oil pan
3. Revision or replacement of spark plugs