SSR 189 - Checking and Cleaning the Air Filter

DIRT BIKE OWNERS MANUAL SSR189
4. Tighten the spark plug, if it is new: 1/2 turn with a wrench spark plug
to compress the washer. If the spark plug is already used, tighten only
between 1/8 and 1/4 turn after having settled.
5. Replace the spark plug cap.
• Whenever the spark plug must be properly tightened to prevent very
hot and possibly damage the engine.
- Disassemble process:
1. Remove the air filter cover
2. Remove the screw and disassemble the air filter
- Cleaning:
1. Being a paper filter element can be cleaned with
pressurized air, by blowing from inside to outside.
2. It is recommended to replace according to maintenance
table indicates since it may make factors such as fuel
consumption, pollution and engine life.
NOTES
• The air filter element must be intact, otherwise, the engine
absorb dust and pollutants and period of engine life will be
shortened.
• Avoid getting water in the air filter during washing dirt bike
• Never clean the air filter element with water, gasoline or any
liquid.
6. Throttle cable adjustment
1. Measure the throttle cable free play, the stipulated value
should be 2-6mm.。
• If the throttle cable free play is not within the parameters
stipulated by adjusting the distance adjuster (regulator)
located after the curve
• Never use an improper heat range plug, because it could
cause engine damage.
• We recommend using spark plug D8TC/D8RTC.
4.Check gasoline filter and replacement
1. Remove the filter hose and drain the gasoline remaining in the
circuit
2. Remove the filter
3. Install the new filter and reconnect the hose
5. Checking and Cleaning the air filter
The air filter should be removed and disassembled to see if
contaminated.