st model Fox - Assemble the Airplane; Install the Fuselage

(2)、Before charging, disconnect the battery with any power. After each flight ,
removethe pack from the airplane and allow it to cool completely before
recharging.
(3)、During the charging process, keep the charger or battery pack in a normal
temperature area and away from source of ignition. Do not cover the charger
or battery pack with carpet, clothe or anything else. Air circulation is necessary
for proper cooling.
(4)、Important: Never leave a charging battery unattended. Please stop
charging immediately of the battery temperature rise rapidly.
Please choose the proper power, battery and transmitter or it will reduce the
longevity under the incorrect improvements.
Tool will be required for assembly as below
ASSEMBLE THE AIRPLANE
Nipper pliers Screw driver Spanner
5.5mm
INSTALL THE FUSELAGE
1、Parts for installation:
(1)、Fuselage ;
(2)、Horizontal Stabilizer
;
(3)、Screw ;
(4)、Left Wing & Right
Wing ;
(5)、Carbon Rod ;
(PIC.06)
(PIC.07)
(PIC.08)
(PIC.09)
(PIC.10)
2
3、Install the horizontal stabilizer onto the holder on fin as
picture shows ;
4、Fix the horizontal stabilizer with the screw to avoid
loosening ;
5、Insert the carbon rod through one of the wings ,
and then put the other end of carbon rod through the
fuselage and the other wing .
、Install the “Z”end of push rod to the horn of elevator ;(PIC.11)
(PIC.12,PIC.13)
(PIC.14)
(PIC.15)
(PIC.16)
(PIC.06) (PIC.07)
(PIC.08)
(PIC.09) (PIC.10)
(PIC.11)