To Next PageTo Next Page
Need help?Do you have a question about the STA-RITE DYNA-PRO MPRA Series and is the answer not in the manual?
General| Model | DYNA-PRO MPRA Series |
|---|---|
| Category | Water Pump |
| Type | Centrifugal Pump |
| Voltage | 115/230V |
| Phase | Single Phase |
| Material | thermoplastic |
| Port Size | 2 inch |
| Inlet Size | 2 inch |
| Outlet Size | 2 inch |
Critical warning about avoiding pool drains and suction outlets to prevent entrapment.
Details on limb, hair, body entrapment, evisceration, and mechanical entrapment.
Guidelines for minimizing suction entrapment risks and VGB Act requirements.
Caution regarding pressurized air during start-up and servicing to prevent separation.
Requirements for pump placement, stability, and suction/discharge pipe connections.
Mandates for suction outlet covers, spacing, and safety compliance for pool use.
Specifications for suction fitting velocity and appropriate pipe fittings.
Essential steps for safely grounding and bonding the motor and pump system.
Guidance on matching supply voltage and connecting wires for pump operation.
Instructions on how to fill the pump and system with water to start operation.
Steps for inspecting and cleaning the strainer basket for optimal pump performance.
Procedures for protecting the pump from freezing and long-term storage.
Detailed steps for taking the pump apart to remove and replace the shaft seal.
Instructions for reassembling the pump after seal replacement, including torque specs.
Diagnosing and resolving problems related to suction leaks and lost prime.
Identifying and fixing issues caused by clogged components or worn parts.
Troubleshooting electrical faults, noise, and mechanical problems.
A visual guide with part numbers for ordering replacements for pump components.
