Need help?Do you have a question about the STA-RITE C Series and is the answer not in the manual?
General| Category | Water Pump |
|---|---|
| Type | Centrifugal |
| Model | C Series |
| Flow Rate | Varies by model |
| Seal Type | Mechanical |
| Weight | Varies by model |
| Horsepower | 0.5 - 5 HP |
| Voltage | 115/230V, 208-230/460V |
| Phase | Single or Three |
| Connection Size | NPT or Flange (Varies by model) |
| Wet End Material | Cast Iron |
| Motor Type | TEFC |
| Port Size | 1 1/2", 2", 3" (Varies by model) |
Explains safety symbols and general safety rules for the pump.
Guidelines for choosing the best location for the pump.
Instructions on how to install suction and discharge piping.
Explains the importance and procedure for grounding the motor.
Information on connecting the pump to the power supply and wiring.
Step-by-step guide on how to prime the pump before operation.
Instructions for storing the pump to prevent damage.
Steps to follow when starting the pump after a period of storage.
Explains how to replace the shaft seal on the pump.
Detailed steps for installing a new shaft seal.
Lists common pump problems, their causes, and solutions.
Exploded view and part list for suction traps (6", 8", 11").
Lists and illustrates parts for 3 HP motor configurations.
Lists and illustrates parts for 5 HP motor configurations.
To Next Page