EasyManua.ls Logo

STA-RITE MAX-E-PRO P6RA6E-205L - User Manual

STA-RITE MAX-E-PRO P6RA6E-205L
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
MAX-E-PRO®
POOL AND SPA PUMP
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
INSTALLATION AND
USER’S GUIDE

Table of Contents

Questions and Answers

  • L
    Lisa TuckerAug 9, 2025
    How to fix STA-RITE Water Pump failure to pump water?
    • A
      Alex SmithAug 9, 2025
      If your STA-RITE Water Pump is not pumping water, has reduced capacity, or the discharge pressure is low, start by checking for suction leaks and ensuring the pump volute and strainer basket are full of water. Inspect the suction piping for leaks and make sure the suction pipe inlet is well below the water level to prevent the pump from sucking air. Also, verify the strainer pot/basket isn't clogged. Clean it if necessary. Check the voltage at the motor terminals and at the meter while the pump is running. Low voltage may indicate an electrical issue. Inspect for loose electrical connections. If the pump is trying to push water too high, consider using a higher head pump.
  • A
    austinwardAug 17, 2025
    Why is my STA-RITE Water Pump overheating?
    • J
      jefferykellerAug 17, 2025
      If your STA-RITE Water Pump is too hot, check the line voltage. If it's less than 90% or more than 110% of the rated voltage, consult a licensed electrician. Increase ventilation to the pump, reduce the ambient temperature, and tighten any loose electrical connections.
  • D
    David WatsonAug 25, 2025
    What to do if STA-RITE Water Pump impeller is clogged?
    • B
      Bryan WillisAug 25, 2025
      If your STA-RITE Water Pump isn't working properly due to a clogged pipe or impeller, or a worn impeller/diffuser, first ensure the strainer pot/basket is not clogged and clean it if needed. Then, check if the impeller is clogged. If you find a blockage, clear it. Inspect the impeller and diffuser for wear. If either shows signs of damage or major wear, order replacement parts.
  • A
    Anna CookAug 31, 2025
    Why is my STA-RITE Water Pump running slowly?
    • T
      Tonya VillaSep 1, 2025
      If your STA-RITE Water Pump is running too slowly, check the voltage at the motor terminals and at the meter while the pump is running. If the voltage is low, see the wiring instructions or consult the power company. Inspect for loose electrical connections.

Summary

INSTALLATION

Location

Piping

Pump Suction Requirements

Suction Outlet Covers

Requirements for anti-entrapment suction outlet covers.

Electrical Installation

Wiring

Instructions for connecting motor wiring, including voltage and wire size.

Grounding

Procedures for permanently grounding the motor and pump.

Bonding

Requirements for bonding the motor to the pool structure and metal components.

OPERATION

Priming the Pump

Steps to follow to fill the pump and suction lines with water for operation.

Draining the Pump

MAINTENANCE

Cleaning the Strainer Basket

Pump Disassembly; Removing Old Seal

STA-RITE MAX-E-PRO P6RA6E-205L Specifications

General IconGeneral
BrandSTA-RITE
ModelMAX-E-PRO P6RA6E-205L
CategoryWater Pump
LanguageEnglish

Related product manuals