Individual *Switch Setting
Model Motor Full Branch Circuit Cord in inches (mm)
Number HP Load Amps Required (Amps) Length
On Off
DC233110T 1/3 9.8 15 10' 13" (330) 4" (102)
DC233110V 1/3 9.8 15 10' 7" (178) 2" (51)
DC233110M 1/3 9.8 15 10' – –
DC233120T 1/3 9.8 15 20' 13" (330) 4" (102)
DC233120V 1/3 9.8 15 20' 7" (178) 2" (51)
DC233120M 1/3 9.8 15 20' – –
DC233130T 1/3 9.8 15 30' 13" (330) 4" (102)
EC240110M 4/10 12.5 15 10' – –
EC240110T 4/10 12.5 15 10' 14" (356) 5" (127)
EC240120M 4/10 12.5 15 20' – –
EC240120T 4/10 12.5 15 20' 14" (356) 5" (127)
DC250110T 1/2 12.5 15 10' 13" (330) 4" (102)
DC250110V 1/2 12.5 15 10' 7" (178) 2" (51)
DC250110M 1/2 12.5 15 10' – –
DC250120T 1/2 12.5 15 20' 13" (330) 4" (102)
DC250120V 1/2 12.5 15 20' 7" (178) 2" (51)
DC250120M 1/2 12.5 15 20' – –
EC2 and DC2 Series
Submersible
Sump/Effluent Pumps
INSTALLATION, OPERATION, & PARTS MANUAL
SAFETY INFORMATION
Carefully read and follow all safety instructions in this
manual or on pump.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for
personal injury!
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
DESCRIPTION
These Submersible Sump Pumps are designed for home
sumps. The unit is equipped with a 3-prong grounding-type
power cord. The shaded-pole motor is oil filled and sealed
for cooler running. Upper sleeve/lower ballbearing on the
motor shaft never need lubrication. Automatic reset thermal
protection.
SPECIFICATIONS
Power supply required........................................115V, 60 HZ.
Motor Duty ............................................................Continuous
Liquid Temp. Range ..........................32°F to 130°F (0°-54°C)
Individual Branch DC233 Series...........................15 Amps
Circuit Required: EC240 Series...........................15 Amps
DC250 Series...........................20 Amps
Discharge Adapter (DC and EC Series)................1-1/2" NPT
PERFORMANCE
© 2008 S506 (Rev. 2/7/08)
293 Wright Street • Delavan, WI 53115
GPM (LPM) AT TOTAL FEET (m)
5101520
Model (1.5m) (3m) (4.6m) (6.1m)
CAPACITY GALLONS(L)/MINUTE
DC233 48 40 29 15 24 Ft.
Series (182) (151) (110) (57) (7.3m)
EC240 62 53 46 38 32 Ft.
Series (235) (201) (174) (144) (9.8m)
DC250 62 53 46 38 32 Ft.
Series (235) (201) (174) (144) (9.8m)
No flow
at height
shown
below
MOTOR, SWITCH, & CORD SPECIFICATIONS
To Next Page
Need help?
General
