Technical characteristics
General
Channels: 40 (80)
Modulation modes: AM/FM
Frequency ranges: from 26.565 MHz to 27.405 MHz
Antenna impedance: 50 Ohms
Power supply: 13.2 V
Dimensions (WxHxD): 116 x 36 x 168 mm
Weight: 0.8 kg
Accessories supplied: Electret microphone with
support,
mounting device,
screws.
Filter: ANL (Automatic Noise Limiter)
built-in
Transmission
Frequency stability: +/- 300 Hz
Transmission power: 1 W AM / 4 W FM
Transmission interference: inferior to 4 nW (- 54 dBm)
Frequecy response: 300 Hz to 3 KHz in AM/FM
Emitted power in the adj. chann.: inferior to 20 µW
Microphone sensitivity: 10 mV
Power consumption: 1.5 A max.
Modulated signal distortion: 1.8 %
Reception
Maxi. sensitivity at 20 dB sinad: 0.7 µV - 110 dBm (AM)
0.35 µV - 116 dBm (FM)
Frequency response: 300 Hz to 3 kHz in AM/FM
Adjacent channel selectivity: 60 dB
Maximum audio power: 5 W
Squelch sensitivity: minimum 0.2 µV - 120 dBm
maximum 1 mV - 47 dBm
Frequency image rejection rate: 60 dB
Intermediate frequency rej. rate: 70 dB
Power consumption: 500 mA nominal
Trouble shooting
Your CB radio does not transmit or your transmission power
is poor:
Check that the antenna is correctly connected and that the SWR
is properly adjusted.
Check that the microphone is properly plugged in.
With the "push-to-talk" switch activated, the display flashes. Release
the "push-totalk" switch, then press it again to reactivate the trans-
mission mode.
26
To Next Page
Loading...
