3332
USE AS A FIRE
After barbecuing, the
stack/// grill
can be converted into a re. The
embers left over from the barbecue
can be used to light the wood.
To do this, proceed as follows:
1. Make sure that the grill rack
3
is hooked into the locking lugs
of the charcoal container
4
.
If necessary, pull out the grill rack
using the barbecue tongs and hook
it in on the charcoal container.
2. Hook the barbecue tongs into
the top / right side part
2
and
carefully place the
stack/// grill
upright (PictureG,1.).
3. Slide the top / right side part
back using the barbecue tongs
(PictureG,2.), remove it from the
charcoal container (PictureG,3.)
and place it down on a heat-
resistant surface.
4. Fill the charcoal container with
wood through the openings
at the top
e
. Do not overll
the charcoal container.
To use the
stack/// grill
directly as a re,
perform the steps below:
1. Fill the chambers of the charcoal
container
4
evenly with wood
and approx. 2 – 3 relighters.
Do not overll the charcoal
container. The relighters should
be placed in the bottom of the
charcoal container.
2. Place the grill rack
3
on the
charcoal container and slide it on
as far as it will go. The small locking
lugs on the charcoal container must
engage in the slots on the side of
the grill rack (PictureC).
3. Set up the bottom side part
1
so
that the logo
stack///
can be read.
4. Place the charcoal container verti-
cally on the bottom side part and
hook it in (PictureD).
Align the open side of the charcoal
container at the top and the grill
rack towards the logo.
The large locking lugs on the
charcoal container must engage
in the two slots on the side part.
5. Slide the charcoal container back
on the side part as far as it will go.
6. Light the relighters in the charcoal
container, e.g. using a long lighter.
7. If necessary, add more wood through
the openings at the top. Do not
overll the charcoal container.
ENEN
To Next Page
Loading...
General