STACYC 12EDRIVE - Troubleshooting and Error Codes; Error Codes; Troubleshooting Common Issues

P a g e | 24P a g e |
PROBLEM:
POSSIBLE CAUSE:
SOLUTION:
Power Switch
is turned “ON”,
cycle does not
work
Baery not installed or fully seated
Verify a fully charged baery is installed
unl baery release buon “clicks”
Verify the baery is fully charged
Verify the fuse is good and properly
installed. Look for water damage. Replace
the fuse with the correct amperage fuse
Baery not fully charged
Fuse not installed or burnt-out
height is achieved, then ghten the adjustment clamp. The seat post is marked with
anindicator line. Do not extend past the indicator line.
Note: Low seat height is recommended. Low seat height allows the operator to easily reach the
ground for more secure foong, and increases rider condence.
Baery and Baery Disposal:
Refer to baery manufacturer documentaon for proper baery maintenance.
Baery Disposal: Your cycle uses sealed lithium cell baeries which must be recycled or
disposed of in an environmentally safe manner. Do not dispose of a lithium cell baery in a
re; the baery may explode or leak. Do not dispose of a lithium cell baery in your regular
household trash. The incineraon, land lling or mixing of sealed lithium cell baeries with
household trash is prohibited by law in most areas. Return exhausted baeries to a federal or
state approved lithium cell baery recyclers or a local seller of baeries. Many states have laws
prohibing the disposal of lithium cell baeries in the municipal waste stream. Check with
your local state law.
Wheels/Tires:
Wheels and res are subject to normal wear and tear. It is the responsibility of the user and
parent to periodically inspect wheels and res for damage and excessive tread wear. Do not
operate with worn or damaged res.
TROUBLESHOOTING GUIDE
A fully charged baery must be installed prior to performing any troubleshoong and must
ONLY be performed by an adult.
ERROR CODES
POWER
SWITCH
THROTTLE
POSITION
SITUATION/ REACTION
LED
ON
ON
ZERO TO
FULL
ZERO TO
FULL
Flashing
YELLOW
Flashing
RED
ESC overload error, reset by turning POWER SWITCH
“OFF”, then back “ON”
Temperature error, reset by turning POWER SWITCH
“OFF, then back “ON”; change riding condions and
ride on at ground to cool down cycle