STACYC 12EDRIVE - Changing Power Modes

P a g e | 15
Power→”ON”
Throle→5%-10% rotaon
LED→Green, Yellow, Red
(Full Baery Charge)
Power→”ON”
Throle→5%-10% rotaon
LED→Red
(Low Baery Charge)
Power→”ON”
Throle→5%-10% rotaon
LED→Yellow and Red
(Med-Low Baery Charge)
5. If you connue to twist the throle (10%+), the motor will be
acvated. The more the throle is twisted, the more power is
delivered to the motor, based on the power program selected.
6. Exercise cauon around moving parts and wheels.
7. Contact customer service or go visit:
www.STACYC.com if unsure about any operaonal
procedure.
CHANGING POWER MODES (TO BE PERFORMED BY ADULTS ONLY)
Your cycle is equipped with 3 power modes for dierent skill levels. Training Mode,
Standard Mode and Advanced Modes. We do not advise showing children how to
adjust the modes. Each child should have the mode set by an adult who will be close-
ly supervising the child. DO NOT put your child on the “Advanced” mode without
working through the process of learning the Training and Standard Modes.
Acvate Program Selecon:
1. Ensure power switch is in “OFF” posion.
2. Install Baery.
3. Ensure bike power switch is “OFF” and no LED lights are on, or no
beeps were heard.
o If any LED light is on, turn bike Power Switch to “OFF”
o If you heard a beep, turn bike Power Switch to “OFF”
4. Turn throle gently and hold throle in “FULL” posion. Do
not release.
5. Turn power switch to “ON” posion , do not let throle move from
“FULL” posion.
o The yellow LED light will ash 5 mes, then all the LED lights
will ash and beep 5 mes, all LEDs will remain lit. Wait 1 sec,
then release throle. All LED lights should be o.
o If LED lights are on, repeat from step 3, and be sure not to
twist the throle quickly as it is not in Program Mode.