ST215C User Handbook Page
3
Quick Start Guide
Switch on & wait for kiln temperature display
To run a firing program set up previously press
the ► key
To stop the firing at any time press the ► key
again
To review firing data press the ► key to enter
the programming mode
To change firing data press the ▲ & ▼ keys to
change the displayed value
Use the ► key again as necessary to step to
the next firing value or segment to be reviewed
or changed
To mark the end of a program set a ramp rate to
End with the ▼ key
To exit the programming mode either wait 20
seconds or press the ► key to start firing
If the keyboard is locked then press the ▲ & ▼
keys together & hold down for 5 seconds to un-
lock
To Next Page
Loading...
Need help?
General