Page ST215C User Handbook
26
DO NOT OPEN
(NO USER SERVICEABLE
PARTS INSIDE)
WARNING
ISOLATE KILN & PROGRAMMER FROM ELECTRICAL
SUPPLY BEFORE ATTEMPTING INSTALLATION OR
REPAIR WORK
Installation
Installation Category: II
Pollution Class: 2
100-240V ~ 50/60HZ 1.0A
Fuse: 3.15A Anti-surge
20mm ceramic HRC
IP50
To meet Electromagnetic Compatibility requirements the controller lead should not
exceed 3.0m in length.
This instrument is designed for use mainly in Domestic, Commercial & Light Industrial
environments where electromagnetic interference may cause a loss of accuracy of the
displayed temperature reading of up to 3°C. Specified accuracy will be restored when
the interference is removed.
Safety Warnings
Installer Information
EMC
To Next Page
Loading...