Stage6 S6 - Installation and Maintenance Procedures; Oxygen Sensor Installation Steps; Internal Battery Replacement Process

S6
INSTRUCTIONS
PRECISION REV COUNTER
EN
2.2 Installation of the Oxygen Sensor
1. Drill a 22.5 mm hole into the downpipe of the exhaust,
200 mm away from the exhaust ange. Weld the welding
sleeve into the hole.
2. Mount the oxygen sensor into the welding sleeve.
1
2
2.3 Replacing the Battery
Open the battery cover and remove the battery
using a slotted screwdriver.
Please be sure to use the proper tool when
removing the battery in order to avoid damaging
the clip.
Clip
NOTE
200 mm
18