Stagg HEAD BANGER 10 - Automatic Programs and Standby Mode; Pan, Tilt, and Display Settings

!
AUTO - Automatic Programs Setup
• Press MENU, then Up or DOWN until "AUTO" is displayed, then press ENTER
• "Yes": When this option is selected, the HeadBanger 10 will run automatic
programs if there is no DMX input signal detected.
• "No": When this option is selected, Automatic programs are disabled and the
HeadBanger 10 will use Sound Controlled Programs when no DMX input
signal is detected.
• Press ENTER to confirm
STBY - Standby setup
• Press MENU, then UP or DOWN until "STBY" is displayed, then press ENTER
• "Yes": When no DMX input is detected, the unit will bypass sound controlled
programs or automatic programs and enter standby mode.
• "No": When no DMX input is detected, the unit will activate either sound
control or automatic programs.
• Press ENTER to confirm
PAN - Pan Inversion
• Press MENU, then UP or DOWN until "PAN" is displayed, then press ENTER
• "Yes": The unit inverts the PAN (vertical) movement (up becomes down)
• "No": The unit's PAN movement is run normally.
• Press ENTER to confirm
TILT - Tilt Inversion
• Press MENU, then UP or DOWN until "TILT" is displayed, then press ENTER
• "Yes": The unit inverts the TILT (horizontal) movement (left becomes right)
• "No": The unit's TILT movement is run normally.
LED - Display on/off
• Press MENU, then UP or DOWN until "LED" is displayed, then press ENTER
• "On": When the unit exits the menu and enter run mode, the display will
remain lit and will show the current status
• "Off": When the unit exits the menu and enter run mode, the display will turn off.