EasyManua.ls Logo

Stagg RE-VOLT 1 Series - RE-VOLT15 Specifications; RE-VOLT15 U Specifications

Stagg RE-VOLT 1 Series
8 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EMD Music - 11/2016 Features and Specications are subject to change without notice.
The Bluetooth
®
word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by EMD MUSIC is under license.
TECHNICAL SPECIFICATIONS
RE-VOLT15 WITHOUT WIRELESS
Woofer: 15”, 33 oz, 2” VC
Tweeter: 1” titanium diaphragm driver, 8 ohms
Frequency response: 60 Hz - 20 KHz
Sensitivity: 92 dB +/- 3 dB
Impedance: 4 ohms
Sound pressure level: 95 dB +/- 3 dB
Features: Reverb, Bluetooth
®
wireless technology, trolley
Battery: 12 volts, 7A, rechargeable
Power supply: Built-in charger, IEC input
Microphone inputs: XLR and phone jack combo, phone jack
Line inputs: Phono and auxiliary input, Bluetooth
®
wireless technology
Mix out output: XLR
Controls: Microphone volume, reverb volume, line volume, VCV on/off switch, master
volume, treble, bass, Bluetooth
®
wireless technology on/off
Weight: 17 kg (35.27 lb)
Dimensions: 69 x 43 x 40 cm (27.2 x 16.9 x 15.7”)
RE-VOLT15U WITH 2 WIRELESS MICROPHONES
Same specications as RE-VOLT15 with, as extras:
Two wireless cardioid dynamic microphones (neodymium magnet) with display showing
battery level indicator and UHF frequency
Two UHF antennas
Two wireless microphone volume controls
UHF on/off switch