TROUBLE SHOOTING GUIDE
Sensor Wires
Allen Wrench
Wrench
Wrench
Screw
Bungee
Cord
Pliers
4.3.
1.
Disconnect the Sensor Wires. Remove the Meter
Post Assembly hardware with Wrenches and
remove the Meter Post Assembly.
Remove all the Screws from the Right Cover and
remove Right Cover.
Use a Pliers to pull out the current Bungee Cord.
19
The following are instructions for removing the
current BUNGEE CORD(88) and installing the
new BUNGEE CORD(88).
Please take a moment to read the caution posted
on the rower inside the covers.
BUNGEE CORD REPLACEMENT
Over time, the BUNGEE CORD(88) may become frayed or worn. If your Wave Water Rowing Machine
1450 is within the 90 day warranty, a replacement BUNGEE CORD(88) is available by contacting
Stamina Customer Care at customer.care@staminaproducts.com. If your Wave Water Rowing Machine
1450 is not under warranty, you can purchase a replacement BUNGEE CORD(88).
Scissor
Bungee
Cord Tie
2.
Detach the Bungee Cord from the Bungee Pulley
at the bottom of rower to release the Bungee
Cord tension. Unhook the Bungee Cord from the
hook locketed at the bottom of rower. Cut o the
Bungee Cord at the position close to the Bungee
Cord Tie.
Bungee
Pulley
To Next Page
Loading...