1. To store the Stamina® Recumbent Exercise Bike 345, simply keep it in a clean dry place.
2. Adjust the SEAT FRAME(65) to the shortest position. The Stamina® Recumbent Exercise Bike 345
is approximately 49.4 inches long x 21.1 inches wide x 42.3 inches tall. These dimensions will vary.
Please measure your Stamina® Recumbent Exercise Bike 345 if exact dimensions are needed.
3. To move the Stamina® Recumbent Exercise Bike 345, lift up the REAR STABILIZER(6) and use
the Wheels on the FRONT STABILIZER(3).
4. To avoid damage to the electronics, remove the batteries before storing the Stamina® Recumbent
Exercise Bike 345 for one year or more.
The safety and integrity designed into the Stamina® Recumbent Exercise Bike 345 can only be
maintained when the Stamina® Recumbent Exercise Bike 345 is regularly examined for damage and
wear. Special attention should be given to the following:
1. Adjust the TENSION KNOB(29) and verify that it functions properly and the resistance changes.
2. Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that
the left pedal has left hand threads and is tightened by turning counterclockwise.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(80) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(80) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the Stamina® Recumbent Exercise
Bike 345 removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the Stamina®
Recumbent Exercise Bike 345.
8. Keep your Stamina® Recumbent Exercise Bike 345 clean by wiping it o with an absorbent cloth
after use.
STORAGE
MAINTENANCE
15
OPERATIONAL INSTRUCTIONS
HOW TO INSTALL AND REPLACE BATTERIES:
1. Open the Battery Door on the back of the meter.
2. The meter operates with two AAA batteries (1.5V each), the batteries are
not included. Refer to the illustration to install or replace the batteries.
1. Do not mix a new battery with an old battery.
2. Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
3. Rechargeable batteries are not recommended.
4. Ultimate disposal of battery should be handled according to
all state and federal laws and regulations.
5. Do not dispose of batteries in re.
NOTE:
AAA Batteries
To Next Page
Loading...
