Stamina 876 - Maintenance; Trouble Shooting Guide

The safety and integrity designed into the STAMINA® Air Resistance Bike 876 can only be maintained
when the STAMINA® Air Resistance Bike 876 is regularly examined for damage and wear. Special
attention should be given to the following:
1. Adjust the TENSION KNOB(27) and verify that it functions properly and the resistance changes.
2. Use a wrench to verify that the PEDALS(31, 32) are tightened securely. If tightening is required,
tighten the pedals rst, then tighten the THIN NUTS(35) securely.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(71) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement CAUTION LABEL(71) if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components must be replaced immediately or the STAMINA® Air Resistance Bike
876 removed from service until repair is made.
7. Only Stamina Products supplied components should be used to maintain/repair the STAMINA® Air
Resistance Bike 876.
8. Keep your STAMINA® Air Resistance Bike 876 clean by wiping it o󰀨 with an absorbent cloth after
use.
MAINTENANCE
14
PROBLEM CORRECTION
Replace batteries. (Use two AA.)1.
CAUSE
Batteries weak or dead.1.No display on meter.1.
Securely plug sensor into the
connecting wire on the meter.
Replace speed sensor.
Replace meter.
Adjust belt - See page 15 belt
tension adjustment.
1.
2.
3.
1.
Sensor wire not connected to
meter.
1.
Speed sensor not working
properly.
2.
Meter not working properly.3.
Belt is too loose.1.
No speed or distance displays
on meter.
2.
Belt slipping when pedaling.3.
Fan needs adjustment.1.Resistance too high.5. Adjust fan per instructions on
page 15 and 16.
1.
Bike is not level.1.Bike rocks as you pedal. Adjust leveling caps on front
stabilizer until bike is level.
1.
4.
TROUBLE SHOOTING GUIDE
IT IS NOT NECESSARY TO RETURN ENTIRE BIKE FOR A MONITOR REPAIR.
THE MONITOR IS REMOVABLE FROM BIKE FOR REPAIR OR REPLACEMENT.