VLH-3000Page 16
8 MAINTENANCE
The inherent quality of the solid-state components used in the VLH-3000
will provide many years of continuous use. Taking the following precautions
will prevent damage to the VLH-3000.
Keep the rear terminal strip from being directly exposed from direct wa-
ter spray
Ensure that the supply voltage to the transceiver does not exceed 16
VDC or fall below 11 VDC.
Use only STANDARD HORIZON-approved accessories and replacement
parts.
In the unlikely event of serious problems, please contact your Dealer or our
repair facility. Address and phone numbers for this facility, as well as war-
ranty information, are contained in section “9 WARRANTY.”
8.1 Replacement Parts
Occasionally an owner needs a replacement mounting bracket or knob.
These can be ordered from our Parts Department by writing or calling:
Marine Division of Vertex Standard
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
Telephone (714) 827-7600
Commonly requested parts, and their part numbers are listed below.
• Power Cord: T9024907
• Dust Cover: RA0772200
• LISTEN/PWR or IC Knob Assy: RA0785500
• PA Knob Assy: RA0785400
• Mounting Bracket: RA0773200
• Mounting Bracket Knob: RA045910A
• Microphone Hanger:RA0458800
To Next Page
Loading...
Need help?
General