Need help?Do you have a question about the Stanley Bostitch N80S and is the answer not in the manual?
General| Operating Pressure | 70-120 psi |
|---|---|
| Power Source | Pneumatic |
| Fastener Diameter | 0.113 to 0.131 inches |
| Shots per Load | 70 |
| Fastener Length | 2 in to 3-1/4 in |
Essential eye and ear protection requirements for operator safety.
Warnings regarding power source, pressure limits, connections, and disconnections.
Safety guidelines to prevent accidental injuries during tool loading.
General and specific safety instructions for operating the tool.
Specifies air fitting, operating pressure, and consumption for optimal performance.
Guidelines for choosing air supply sources and pressure regulators.
Recommendations for optimal operating pressure and air filter maintenance.
Mandatory precautions and rules for safe tool usage.
Troubleshooting for failure to cycle, lack of power, and slow cycling.
Causes and solutions for skipping fasteners and jams in the tool/canister.
To Next Page