Stanley FatMax FMFP71928 User Manual

OPERATION and MAINTENANCE MANUAL
MANUAL DE OPERACIÓN Y DE MANTENIMIENTO
MANUEL D’INSTRUCTIONS ET D’ENTRETIEN
9R197558RA 11/12
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO
UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE
INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY
QUESTIONS, CONTACT YOUR STANLEY TOOLS REPRESENTATIVE OR DISTRIBUTOR.
ANTES DE OPERAR ESTA HERRAMIENTA, TODOS LOS OPERADORES DEBERÁN
ESTUDIAR ESTE MANUAL PARA PODER COMPRENDER Y SEGUIR LAS ADVERTENCIAS
SOBRE SEGURIDAD Y LAS INSTRUCCIONES. MANTENGA ESTAS INSTRUCCIONES CON
LA HERRAMIENTA PARA FUTURA REFERENCIA, SI TIENE ALGUNA DUDA, COMUNÍQUESE
CON SU REPRESENTANTE DE STANLEY TOOLS O CON SU DISTRIBUIDOR.
LIRE ATTENTIVEMENT LE PRÉSENT MANUEL AVANT D’UTILISER L’APPAREIL. PRÉTER
UNE ATTENTION TOUTE PARTICULIRE AUX CONSIGNES DE SÉCURITÉ ET AUX
AVERTISSEMENTS. GARDER CE MANUEL AVEC L’OUTIL POUR FUTUR RÉFÉRENCE. SI
VOUS AVEZ DES QUESTIONS, CONTACTEZ VOTRE REPRÉSENTANT OU VOTRE
CONCESSIONNAIRE STANLEY TOOLS.
FMFP71928
18 GAUGE BRAD NAILER
CLAvADoRA DE pUNtILLAs DE CALIBRE 18
CLoUEUsE DE vItRIER DE CALIBRE18
FMFP71928_9R197558RA_18GA BRAD NAILER_MAN_JM_SB1850BN_9R195756RA_FM_SB1850BN_MAN_CC 1/

Stanley FatMax FMFP71928 Specifications

General

Brand	Stanley
Model	FatMax FMFP71928
Category	Nail Gun
Language	English

Summary

Safety Instructions

Eye Protection Requirements

Mandatory eye protection conforming to ANSI Z87.1 standards for frontal and side protection.

Air Supply and Connections

Power Source Requirements

Use only clean, regulated compressed air; never oxygen or combustible gases.

Regulator and Filter Usage

Requires a 0-125 p.s.i.g. regulator and emphasizes filter maintenance for optimal performance.

Operating Pressure Range

Recommended operating pressure is 70-100 p.s.i.g. Do not exceed.

Loading the Nailer

Loading Safety Precautions

Emphasizes wearing eye protection and avoiding accidental discharge during loading.

Tool Operation

Operation Safety Warnings

General safety rules for operation, including trigger discipline and handling.

Sequential Trip Operation

Describes the sequential trip mechanism for accurate fastener placement.

Maintaining the Pneumatic Tool

Trouble Shooting

Failure to Cycle

Lack of Power or Slow Cycling

Fastener Jamming