12
Cordless Tool
B. Safety Instructions for Cordless Tools and Controllers
WARNING
ELECTRICAL HAZARD
To Avoid Injury:
• Save these instructions for future reference.
• Read and understand all the safety recommendations and all operating instructions before operating tools and control-
lers. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.
• Train all operators in the safe and proper use of power tools. Operators should report any unsafe condition to their super-
visor.
• Follow all safety recommendations in the manual that apply to the tools, battery packs and chargers being used, and the
nature of the work being performed.
• Verify that all warning labels illustrated in this manual are readable. Replacement labels are available at no additional
cost from STANLEY Assembly Technologies.
• Only allow suitably qualified personnel to install, program, or maintain this equipment and or system. Follow all manufac-
turer installation instructions and applicable regulatory electrical codes and safety codes.
• These persons must be knowledgeable of any potential sources of danger and maintenance measures as set out in the
Installation, Operations, and Maintenance manual.
• This product must be transported, stored, and installed as intended, and maintained and operated with care to ensure
that the product functions correctly and safely.
• Persons responsible for system planning and design must be familiar with the safety concepts of automation equipment.
• Install tools in dry, indoor, non-flammable, and non-explosive environments only–Humidity: 0 to 95% noncondensing and
Temperature: 32 to 122. F (0 to +50 .C).
• Do not install worn, damaged, or modified equipment that may be unsuitable for safe use.
• Controller plugs must match the outlet and must be earth grounded. Never modify a plug in any way or use any adaptor
plugs.
• Avoid body contact with electrically energized surfaces when holding a grounded tool.
• Prior to connecting a power source, always ensure the tool or controller is turned off.
• Limit controller access to trained and qualified personnel. Lock controller cabinets.
• Only use equipment and accessories specifically designed to operate with STANLEY Assembly Technologies tools and use
them only in the manner for which they are intended.
• Store idle tools and accessories in a safe location accessible only by trained persons.
• Disconnect power source (battery pack, electricity, etc.) from tool or controller prior to adjusting, changing accessories, or
storing.
• Prior to operation, always check and test tools and accessories for damage, misalignment, binding or any other condition
that may affect operation. Maintenance and repair should be performed by qualified personnel.
• Do not operate tools in or near explosive environments or in the presence of flammable liquids, gases, dust, rain or other
wet conditions.
• Keep the work area clean, well-lit and uncluttered.
• Keep unauthorized personnel out of the work area.
• Install tools and controllers in dry, indoor, non-flammable, and non-explosive environments only.
• Do not use this product near water, for example near a washbowl, wet basement, or the like.
• This product should be located away from heat sources such as radiators or other devices that produce heat.
• This product should not be subjected to vibration or shock or in close contact with water or other liquids.
• To minimize electrical interference, place the tools and controllers as far away from possible sources of electrical noise,
such as arc welding equipment.
To Next Page
Loading...
Need help?
General
