8
Cordless Tool
1.1 About the Cordless Tool
A BR-Series Cordless Tool from STANLEY Assembly Technologies is designed to secure, or fasten, blind rivet fasteners in
industrial assembly operations. It utilizes closed loop monitoring of force, speed, and distance so that it can perform various
routines to secure each rivet with the highest quality results. High precision sensors provide feedback to the integrated digi-
tal control circuit. This circuit compares the feedback values to the programmed values and adjusts the servo motor’s power
and speed values to maintain the programmed speed on the output of the tool until the rivet has been set. Once the tool
senses that the rivet has been set, it reports the setting force and distance and whether it met the specified parameters.
The BR-Series Cordless Tool uses a Lithium Ion battery pack as its power source.
Use the recommended Lithium Ion Battery Charger to charge the battery pack.
Programming strategies into the BR-Series Cordless Tool can be done with or without a STANLEY Assembly Technologies
QBE controller. The cordless tool has an embedded transceiver and communicates to the QBE Controller via an IEEE 802.11
a/b/g/n WIFI connection. See section 2.16 “Pairing Tool to Controller” on page 32 for instructions on pairing the cordless
tool to the controller. See the QBE controller manual for instructions on programming.
CONNECTING TO WIFI
WIFI Specifications: IEEE 802.11a/b/g/n
Band Support:
2.4 GHz, channel 1-13*
5 GHz, channel 36-165*
Security
OPEN
WPA2 AES/CCMP, TKIP
PEAP
*Actual channels available may be reduced to IEEE 802.11d, depending on the region.
After programming, the tool can remain paired to the controller for program selection, error proofing operations or data
management requirements or it can be used independent of the controller.
The BR-Series Cordless Tool stores data for 500 cycles and 2 traces (starting Version 5.2.15). These values can be viewed
and retrieved using the QBE Controller or STANLEY Alpha ToolBox software utility.
Periodic preventive maintenance and calibration will keep the BR-Series Cordless Tool in optimum working condition allow-
ing it to continue to achieve high quality results.
1.2 Tool Components
Tool components are explained in chapter 3 “Tool Operation” on page 37.
The standard output that is shipped with each pistol tool is the 4.8mm (3/16”) size nose assembly. However, 4.0mm (5/32”)
or 3.2mm (1/8”) size nose assemblies can be requested. The battery pack and charger and their operation are explained in
chapter 2 “Getting Started” on page 23.
To Next Page
Loading...
Need help?
General
